To measure and control dust particulates in the foundry, dry dust tec – McqOptions

MCQOPTIONS

1.	To measure and control dust particulates in the foundry, dry dust technologies are mostly preferred than the wet dust technologies.
A.	True
B.	False
Answer» B. False

Discussion

No Comment Found

Related MCQs

Respirable dust sampling is a method which uses a cyclone to separate and capture dust particles.
In non-ferrous foundries, dust from the emission control equipment is considered as hazardous waste which cannot be recoverable.
To measure and control dust particulates in the foundry, dry dust technologies are mostly preferred than the wet dust technologies.
The biological monitoring of carbon monoxide is basically done by the blood sampling procedure.
IN_NON-FERROUS_FOUNDRIES,_DUST_FROM_THE_EMISSION_CONTROL_EQUIPMENT_IS_CONSIDERED_AS_HAZARDOUS_WASTE_WHICH_CANNOT_BE_RECOVERABLE.?$
Respirable_dust_sampling_is_a_method_which_uses_a_cyclone_to_separate_and_capture_dust_particles.$
To measure and control dust particulates in the foundry, dry dust technologies are mostly preferred than the wet dust technologies?
Which of the following processes is responsible for the emission of particulate matter in the foundry?
Mechanization in the foundry can reduce the level of dust which may further reduce the cost of sampling.
To examine health hazards and material damages in the foundry, the sampling site should be away from the source of pollution.