The width of belt is 15 cm and maximum tension per cm width is not to exceed 12 kg. T1/T2=2.25. Diameter of driver=1m and it makes 220 rpm. Find the horse power that can be transmitted.

The width of belt is 15 cm and maximum tension per cm width is not to

1.	The width of belt is 15 cm and maximum tension per cm width is not to exceed 12 kg. T1/T2=2.25. Diameter of driver=1m and it makes 220 rpm. Find the horse power that can be transmitted.
A.	11.35 HP
B.	10.23 HP
C.	12.12 HP
D.	9.86 HP
Answer» C. 12.12 HP

Discussion

No Comment Found

Related MCQs

Find the gear ratio of a tractor of its final drive of tractor has 1.2 m tractor wheel and forward speed of 5km/h. When engine is running at 1000 rpm if reduction in transmission is 3:1
If it desired to obtain 160 kgm torque at the transmission output shaft, what gear ratio would be necessary if transmission efficiency is 96% and the input torque is 15 kg m?
A tractor has belt speed of 1000 m/min at normal engine speed. A feed mill has a recommended speed of 2100 rev/min. Find the size of pulley, needed on the Feed mill.
The width of belt is 15 cm and maximum tension per cm width is not to exceed 12 kg. T1/T2=2.25. Diameter of driver=1m and it makes 220 rpm. Find the horse power that can be transmitted.
A 2-wheel drive 35hp tractor has 1.5 rear wheel diameter. The engine runs at 1200 rev/min. the total reduction of speed is 30:1. Find the travelling speed of the tractor in km/h and the tractive force at each driving wheel.
While turning a 4-wheel tractor equipped with the Ackermann steering mechanism the axis of the inner front wheel makes an angle of 45 , whereas the angle made by the axis of the outer front wheel is 30 with horizontal line parallel to the front axle. The kingpins of the axle are 1300 mm apart. The spindle genths are essentially zero. What should be the wheel base of the tractor if there is no slippage of any of the wheels?
If the inner and outer steering angle in a tractor are 9 and 9.8 respectively then for correct steering conditioning the value of the ratio of pivot axis spacing to track length is equal to ______

The width of belt is 15 cm and maximum tension per cm width is not to exceed 12 kg. T1/T2=2.25. Diameter of driver=1m and it makes 220 rpm. Find the horse power that can be transmitted.

Discussion

No Comment Found

Related MCQs

Reply to Comment