The value of impulse at t=0 is __________ – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Electric Drives
→ Slip Energy Recovery in Electric Drives
→ The value of impulse at t=0 is __________..

1.	The value of impulse at t=0 is __________
A.	0
B.	2
C.	1
D.	infinite
Answer» E.

Discussion

No Comment Found

Related MCQs

Calculate the equivalent capacitance when two capacitors are connected in parallel of values 8 F, 7 F.
Calculate the equivalent resistance when two resistances are connected in parallel of values 2 Ω, 2 Ω.
Selectivity value increases for lower values of bandwidths.
Calculate the quality factor for the resistor.
Calculate the value of the inductive reactance during resonance if the value of capacitive reactance is 2 ohm.
The minimum value of the admittance in case of the parallel RLC network is ___________
The nodal method is better than mesh analysis for solving circuit problems.
All loops are meshes.
Mesh analysis is only applied to the planar circuits.
Calculate the total energy stored in the inductor if the current value is 4 A and inductance values are 1 H and 2 H.

Related Topics

Slip Energy Recovery in Electric Drives

Three Phase Half Wave Ac Dc Conversion Resistive Loads in Electric Drives

Effect Load Inertia in Electric Drives

Solar Panels in Electric Drives

Acceleration Time in Electric Drives

Ac Motor Systems in Electric Drives

Controlling Speed Using Inductance in Electric Drives

Basics Principles Speed Control in Electric Drives

Load Equalisation in Electric Drives

Three Phase Synchronous Motors in Electric Drives

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com