The specimen used in the typical bend test (sheet) must have a width – McqOptions

MCQOPTIONS

1.	The specimen used in the typical bend test (sheet) must have a width of _______ inches.
A.	12
B.	4
C.	1
D.	0.56
Answer» D. 0.56

Discussion

No Comment Found

Related MCQs

Fatigue stresses will most likely destroy the material if the bending test is performed on them.
If the bend of a bend test has to be gauged to its complete extent _________ of bend must be computed.
The bending in the bending tests is achieved be either__________ or __________
The edges of a specimen of forging stock are rounded to a ________ radius in a bending test.
It is usually preferred for shop bending to take all the present bends ________ grain.
The specimen used in the typical bend test (sheet) must have a width of _______ inches.
The specimen of the bending test must be taken only parallel to the grain.
The flattening test while being used for bronze tubing must consider the thickness of the tube to be not more than ____ times wall thickness.
In the flattening test, the length of the tubing is taken _________ times of the diameter.
Flattening test is applied to __________