The rectifier current is a short duration pulses which cause the diode – McqOptions

MCQOPTIONS

1.	The rectifier current is a short duration pulses which cause the diode to act as a_________
A.	Voltage regulator
B.	Mixer
C.	Switch
D.	Oscillator
Answer» D. Oscillator

Discussion

No Comment Found

Related MCQs

A shunt capacitor of value 500µF fed rectifier circuit. The dc voltage is 14.43V. The dc current flowing is 200mA. It is operating at a frequency of 50Hz. What will be the value of peak rectified voltage?
The rms ripple voltage (Vrms) of a shunt filter is_________
A full wave rectifier uses a capacitor filter with 500µF capacitor and provides a load current of 200mA at 8% ripple. Calculate the dc voltage.
A 100µF capacitor when used as a filter has 15V ac across it with a load resistor of 2.5KΩ. If the filter is the full wave and supply frequency is 50Hz, what is the percentage of ripple frequency in the output?
A half wave rectifier, operated from a 50Hz supply uses a 1000µF capacitance connected in parallel to the load of rectifier. What will be the minimum value of load resistance that can be connected across the capacitor if the ripple% not exceeds 5?
THE_RMS_RIPPLE_VOLTAGE_(V<SUB>RMS</SUB>)_OF_A_SHUNT_FILTER_IS_________?$
A_shunt_capacitor_of_value_500¬¨¬®¬¨¬µF_fed_rectifier_circuit._The_dc_voltage_is_14.43V._The_dc_current_flowing_is_200mA._It_is_operating_at_a_frequency_of_50Hz._What_will_be_the_value_of_peak_rectified_voltage?$#
Which of the following are true about capacitor filter?
The charge (q) lost by the capacitor during the discharge time for shunt capacitor filter.
A full wave rectifier uses a capacitor filter with 500¬¨¬®¬¨¬µF capacitor and provides a load current of 200mA at 8% ripple. Calculate the dc voltage.$