The pressure coil of a wattmeter should be connected on the supply sid – McqOptions

MCQOPTIONS

1.	The pressure coil of a wattmeter should be connected on the supply side of the current coil when______________?
A.	load impedance is high
B.	load impedance is low
C.	supply voltage is low
D.	none of the above
Answer» B. load impedance is low

Discussion

No Comment Found

Related MCQs

Which of the following meters are not used on D.C. circuits______________?
Which of the following devices should be used for accurate measurement of low D.C. voltage ?
When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is____________?
Wattmeter cannot be designed on the principle of_________________?
Wagner earthing device is used to eliminate errors due to________________?
Volt box is a component to_____________?
Various adjustments in an energy meter include_______________?
Two holes in the disc of energy meter are drilled at the opposite sides of the spindle to_____________?
To measure radio frequency, the suitable frequency meter is_______________?
To measure an A. C. voltage by using an A.C. potentiometer, it is desirable that the supply for the potentiometer in taken_______________?