The original design of the RAMBUS required for � – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Computer Science Engineering (CSE)
→ Software Design Modeling in Computer Science Engineering (CSE)
→ The original design of the RAMBUS required for �..

1.	The original design of the RAMBUS required for data lines.
A.	4
B.	6
C.	8
D.	9
Answer» E.

Discussion

No Comment Found

Related MCQs

The bit is used to indicate the validity of the page.
BUS arbitration approach uses the involvement of the processor.
The read and write operations usually start at of the sector.
The cache bridges the speed gap between and
The multiplier is stored in
In LRU, the referenced blocks counter is set to’0′ and that of the previous blocks are incremented by one and others remain same, in the case of
In a 4M-bit chip organisation has a total of 19 external connections.then it has address if 8 data lines are there.
In the output interface of the parallel port, along with the valid signal is also sent.
The is used to coordinate the operation of the multiplier.
The only difference between the EEPROM and flash memory is that the latter doesn’t allow bulk data to be written.

Related Topics

Software Design Modeling in Computer Science Engineering (CSE)

Information Cyber Security in Computer Science Engineering (CSE)

Software Testing And Quality Assurance in Computer Science Engineering (CSE)

Neural Networks And Fuzzy Control in Computer Science Engineering (CSE)

Digital Logic Circuits in Computer Science Engineering (CSE)

Object Oriented Programming in Computer Science Engineering (CSE)

Usability Engineering in Computer Science Engineering (CSE)

Artificial Intelligence And Robotics in Computer Science Engineering (CSE)

Computer Networking in Computer Science Engineering (CSE)

Data Analysis in Computer Science Engineering (CSE)

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com