The NT flag is set by the task switch operation, that is initiated by – McqOptions

MCQOPTIONS

1.	The NT flag is set by the task switch operation, that is initiated by
A.	CALL
B.	INT
C.	CALL & INT
D.	None of the mentioned
Answer» D. None of the mentioned

Discussion

No Comment Found

Related MCQs

THE_INSTRUCTION_THAT_READS_THE_DESCRIPTOR_ACCESS_RIGHTS_BYTE_INTO_THE_REGISTER_IS?$
THE_INSTRUCTION_THAT_SETS_THE_ZERO_FLAG,_IF_THE_SEGMENT_REFERRED_TO_BY_THE_SELECTOR,_CAN_BE_WRITTEN_AS?$
The instruction that adjusts the RPL (Requested Privilege Level) of the selector, to the numeric maximum of current selector RPL value is$
The instruction that reads the segment limit into the register, if privilege rules and descriptor type allow is$
The instruction that sets the zero flag, if the segment referred to, by the selector can be read i?
The 80286 executes LMSW instruction to enter into
The NT flag is set by the task switch operation, that is initiated by
The IRET instruction gets back the execution state of the previous task, if
The instruction that can be used to carry out task switch operation is
The operation that is provided by the internal architecture, to save the execution state of a task is