The mode that is programmed using ‚Äö√Ñ√∂‚àö√ë‚à� – McqOptions

MCQOPTIONS

1.	The mode that is programmed using ‚Äö√Ñ√∂‚àö√ë‚àö‚à´end interrupt/error mode set command‚Äö√Ñ√∂‚àö√ë‚àöœÄ is$
A.	scanned keyboard special error mode
B.	scanned keyboard with N-key rollover
C.	scanned keyboard mode with 2 key lockout
D.	sensor matrix mode
Answer» B. scanned keyboard with N-key rollover

Discussion

No Comment Found

Related MCQs

THE_FLAG_THAT_INCREMENTS_AUTOMATICALLY_AFTER_EACH_READ_OR_WRITE_OPERATION_TO_THE_DISPLAY_RAM_IS?$
If_any_change_in_sensor_value_is_detected_at_the_end_of_a_sensor_matrix_scan,_then_the_IRQ_line$
The FIFO status word is used to indicate the error i?
The data that is entered from the left side of the display unit is of
When a key is pressed, the debounce circuit waits for 2 keyboard scans and then checks whether the key is still depressed in
The mode that is programmed using ‚Äö√Ñ√∂‚àö√ë‚àö‚à´end interrupt/error mode set command‚Äö√Ñ√∂‚àö√ë‚àöœÄ is$
When a key is pressed, a debounce logic comes into operation in
The registers that hold the address of the word currently being written by the CPU from the display RAM are
The sensor RAM acts as 8-byte first-in-first-out RAM in
The registers that store the keyboard and display modes and operations programmed by CPU are