The meter constant of a single-phase, 230 V induction watt-meter is 60 – McqOptions

MCQOPTIONS

1.	The meter constant of a single-phase, 230 V induction watt-meter is 600 rev/kW-h. The speed of the meter disc for a current of 15 A at 0.8 power factor lagging will be?
A.	30.3 rpm
B.	25.02 rpm
C.	27.6 rpm
D.	33.1 rpm
Answer» D. 33.1 rpm

Discussion

No Comment Found

Related MCQs

In the measurement of 3-phase power by 2 watt-meter method, if the 2 watt-meter readings are equal, the power factor of the circuit is?
The meter constant of a single-phase, 230 V induction watt-meter is 600 rev/kW-h. The speed of the meter disc for a current of 15 A at 0.8 power factor lagging will be?
Choose the correct statement regarding two watt-meter method for power measurements in 3-phase circuit.
The ratio of the reading of 2 watt-meters connected to measure power in a balanced 3-phase load is 2: 1 and the load is inductive. The power factor of load is?
The two-wattmeter method is used to measure active power. The system is a 3-phase, 3- wire system. Then, the power reading is?
A single-phase load is connected between R and Y terminals of a 220 V, symmetrical, 3-phase, 4 wire systems with phase sequence RYB. A watt-meter is connected in the system. The watt-meter will read (pf = 0.8 lagging)?
Power flowing in 3-phase, 3-wire system is measured by two wattmeter whose readings are 7000 W and -2500 W. if the voltage of the circuit is 400 V, then what will be the value of capacitance introduced in each phase to make one wattmeter reads zero? The frequency is 50 Hz.
Two watt meters, which are connected to measure the total power on a three-phase system supplying a balanced load, read 10.5 kW and 2.5 kW respectively. What is the total power?