The industry standard figure of merit for an RF switch is ______ – McqOptions

MCQOPTIONS

1.	The industry standard figure of merit for an RF switch is ______
A.	R0C1
B.	R1C0
C.	C0R1
D.	C1R0
Answer» C. C0R1

Discussion

No Comment Found

Related MCQs

The useful dynamic range applicable for antenna, RF/IF conversion, and ADC s is given by the ratio of smallest processable signal to the smallest detectable signal.
The Nyquist criterion states that the sampling frequency of a band limited analog waveform must be at least ______ component to properly reconstruct the signal.
____ fixes the input power dynamic range such that there are no sinusoidal RF conversion artifacts in the output.
Which of the following is not a challenge to RF/IF conversion stage in military application?
Electronically Programmable Analog Components are also called as ____
10.Which of the following modulation type is incompatible with class C operation?
9.RF amplifiers tend to be ____ amplifiers.
Superconductors use ____ to maintain working temperature near _____
Superconducting analog filters can reduce noise and interference introduced by wide bandwidth of SDR architecture.
RF MEMS allows selection of ____ and ____, increasing the degree of freedom in design process.