The hole size in direct drilling depend up on which of the factors bel – McqOptions

MCQOPTIONS

1.	The hole size in direct drilling depend up on which of the factors below?
A.	Input power
B.	Focusing adjustments
C.	All of the mentioned
D.	None of the mentioned
Answer» D. None of the mentioned

Discussion

No Comment Found

Related MCQs

WHAT_ARE_THE_VALUES_OF_ENTRANCE_ANGLES_THAT_VARY_IN_LASER_DRILLING_PROCESS??$
What is the depth-to-diameter ratio obtained in drilling process using Laser beam machining?$
The taper obtained in Laser drilling process is how much of the hole diameter?$
What is the value of minimum corner radius obtained by drilling in Laser beam machining?
What are the tolerance values obtained when we use laser drilling process?
What is the maximum value of drilling depth in trepanning method of laser drilling process?
What is the value the maximum optimum depth that can be machined using Laser drilling process?
What are the values of diameters obtained by using Laser drilling process?
Which method mentioned below is used for drilling of large size holes?
The hole size in direct drilling depend up on which of the factors below?