The following data pertain to two alternators working in parallel and supplying a total load of 80 MW: Machine 1: 40 MVA with 5% speed regulation Machine 2: 60 MVA with 5% speed regulation The load sharing between machines 1 and 2 will be

The following data pertain to two alternators working in parallel and

1.	The following data pertain to two alternators working in parallel and supplying a total load of 80 MW: Machine 1: 40 MVA with 5% speed regulation Machine 2: 60 MVA with 5% speed regulation The load sharing between machines 1 and 2 will be
A.
B.	40 MW 40 MW
C.	30 MW 50 MW
D.	32 MW 48 MW
Answer» D. 32 MW 48 MW

Discussion

No Comment Found

Related MCQs

A power system has two synchronous generators. The governor-turbine characteristics orresponding to the generators are P1 = 50(50 ), P2 = 100(51 ). where f denotes the system frequency in Hz and P1 and P2 are respectively, the power outputs (in MW) of turbines 1 and 2. Assuming the generat or s and transmission network to be lossless, the system frequency for a total load of 400 MW is __________ Hz
Determine the correctness or otherwise of the following Assertion [a] and the Reason [r]. Assertion: Fast decoupled load flow method gives approximate load flow solution because it uses several assumptions. Reason: Accuracy depends on the power mismatch vector tolerance.
The fuel cost functions of two powr plants are Plant P1 : C1 = 0.05 Pg 1 + APg1 + B Plant P2 : C2 = 0.10 Pg 2 + APg2 + 2B Where, Pg1 and Pg2 are the generated powers of two plants, and A and B are the constants. If the two plants optimally share 1000 MW load at increamental fuel cost of 100 Rs/MWh, the ratio of load shared by plants P1 and P2 is
If a 75 MVA, 10 kV synchronous generator has Xd = 0.4 p.u, then Xd value (in p.u.) to a base of 100 MVA, 11 kV is ___________
In a long transmission line with r, l, g and c are the resistance, inductance, shunt conductance and capacitance per unit length, respectively, the condition for distortionless transmission is
A cable has following characteristics: L = 0.201 H/m and C = 196.2 p/F/m. The velocity of wave propagation through the cable is ________ m/s
When a line-to-ground fault occurs, the current in the phase is 100 A. The zero sequence current in this case will be _______ A
A three phase 50 Hz line consists of three conductors each of diameter 21 mm. The spacing between the conductors as follows: A B = 3m, B C = 5m, C A = 3.6 m If the line operates at 132 kV, the reactive voltampere generatd by the line per km is _______kVAr
If the sheath resistance is 2.14 /km and that of the conduct or is 0.1625 /k m, and mutual inductance of the shealth is 3.13 10 7 H/m. When the cable is 2 km long and supply is 50 Hz, the ratio of sheath loss to core loss of the cable will be_______
A 50 Hz alternator is rated 500 MVA, 20 kV, with Xd = 1.0 per unit and X"d = 0.2 per unit. It supplies a purely resistive load of 400 MW at 20 kV. The load is connected directly across the generator terminals when a symmetrical fault occurs at the load terminals. The initial rms current in the generator in per unit is __________

The following data pertain to two alternators working in parallel and supplying a total load of 80 MW: Machine 1: 40 MVA with 5% speed regulation Machine 2: 60 MVA with 5% speed regulation The load sharing between machines 1 and 2 will be

Discussion

No Comment Found

Related MCQs

Reply to Comment

The following data pertain to two alternators working in parallel and supplying a total load of 80 MW:
Machine 1: 40 MVA with 5% speed regulation
Machine 2: 60 MVA with 5% speed regulation
The load sharing between machines 1 and 2 will be