The design of the projecting parts during the construction of earthqua – McqOptions

MCQOPTIONS

1.	The design of the projecting parts during the construction of earthquake-resistant buildings should be per ________
A.	IS 1833: 2000
B.	IS 1873: 2001
C.	IS 1893: 2002
D.	IS 1993: 2004
Answer» D. IS 1993: 2004

Discussion

No Comment Found

Related MCQs

The vertical thickness of the reinforced concrete band should be _______ minimum where four longitudinal bars are specified.
The width of the reinforced concrete band is taken the same as the __________ of the wall.
The concrete used in coastal areas during the construction of earthquake-resistant buildings should be of grade __________
The window and door openings increase the lateral load resistance of the walls.
Masonry bearing walls should not be built of height greater than _________ subject to a maximum of four storeys when measured from the mean ground level to the ride level during the construction of earthquake-resistant buildings.
Where the masonry is provided with steel reinforcing bars, the bars should be embedded with adequate cover in cement concrete of grade _________
During the construction of earthquake-resistant buildings, it should be kept in mind that those solid concrete blocks should be used which have crushing strength not lesser than _________
The design of the projecting parts during the construction of earthquake-resistant buildings should be per ________
During the construction of earthquake-resistant buildings, ceiling plaster should be avoided. In case it cannot be avoided, it should be as thick as possible.
Earthquake force is a function of __________