MCQOPTIONS
Bookmark
Saved Bookmarks
→
L&T ECC
→
Aptitude & Logical - L&T ECC
→
The cutting angle , for drilling stainless steel s...
1.
The cutting angle , for drilling stainless steel should be:
A.
90°
B.
150°
C.
180°
D.
135°
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
When two elements of a pair have surface contact when in motion, it is said to be :
The cutting angle , for drilling stainless steel should be:
The absence of business schools in Japan
A criticism that management education did not face was that
According to the passage which of the option is true
The following reasons were responsible for the growth of popularity of business schools among students except
Which of the following is absolutely true, about Japenese education syatem, according to the passage ?
George is so lazy that he
The doctor warns him that unless he gives up smoking
There was adequate grazing area for the herds since the land was _______ populated
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
