The angle between normal stress and tangential stress is known as angl – McqOptions

MCQOPTIONS

1.	The angle between normal stress and tangential stress is known as angle of______
A.	declination
B.	orientation
C.	obliquity
D.	rotation
Answer» D. rotation

Discussion

No Comment Found

Related MCQs

What is the S.I. unit of sectional modulus?
Force of 100 kN is applied on 900 mm long rod of 20 mm diameter and is simultaneously heated at 70 C. What is the total elongation of the rod? (Assume coefficient of thermal expansion = 10 x 10 C, Young's modulus = 150 Gpa)
Stress in the cross section of a shaft at the centre ________
Stress on an object due to sudden load is _________ the stress induced when the load is applied gradually.
What is the proof resilience of a square bar of 2500 mmand 200 mm long, when a load of 150 kN is induced gradually?(Take E = 150 x 10 Mpa)
In the relation ( T/J = G /L = / R), the letter G denotes modulus of______
What is the shear stress acting on the outer surface of a hollow shaft subjected to a torque of 100 Nm?(The inner and outer diameter of the shaft is 15 mm and 30 mm respectively.)
In Euler's theory, long columns having the ratio of (L /LLD) 12 fail due to _______
Euler's formula is applicable only _________1. for short columns2. for long columns3. if slenderness ratio is greater than ( E / ) 4. if crushing stress < buckling stress 5. if crushing stress buckling stress
Slenderness ratio is the ratio of effective length of column and ________