Resistances R1 and R2 have respectively, nominal values of 10 and 5 and limiting error of 5% and 10%. The percentage limiting error for the series combination of R1 and R2 is?

Resistances R1 and R2 have respectively, nominal values of 10 and 5

1.	Resistances R₁ and R₂ have respectively, nominal values of 10 and 5 and limiting error of 5% and 10%. The percentage limiting error for the series combination of R₁ and R₂ is?
A.	6.67%
B.	5.5%
C.	7.77%
D.	2.8%
Answer» B. 5.5%

Discussion

No Comment Found

Related MCQs

A 500 A, 50 Hz current transformer has a bar primary. The secondary burden is a pure resistance of 1 and it draws a current of 5 A. If the magnetic core requires 250 Ampere-turn for magnetization, the percentage ratio error is __________
A voltmeter has a sensitivity of 1000 /V reads 200 V on its 300 V scale. When connected across an unknown resistor in series with a millimeter. When the milliammeter reads 10 mA. The error due to the loading effect of the voltmeter is ________
A voltmeter has a sensitivity of 1000 /V reads 200 V on its 300 V scale. When connected across an unknown resistor in series with a millimeter. When the milliammeter reads 10 mA. The actual resistance of the unknown resistor will be?
A voltmeter has a sensitivity of 1000 /V reads 200 V on its 300 V scale. When connected across an unknown resistor in series with a millimeter. When the milliammeter reads 10 mA. The apparent resistance of the unknown resistor will be?
Resistances R1 and R2 have respectively, nominal values of 10 and 5 and limiting error of 5% and 10%. The percentage limiting error for the series combination of R1 and R2 is?
Two resistances 100 5 and 150 15 are connected in series. If the error is specified as standard deviations, the resultant error will be _________
A resistor of 10 k with the tolerance of 5% is connected in series with 5 k resistors of 10% tolerance. What is the tolerance limit for a series network?
The current flowing in a resistor of 1 is measured to be 25 A. But it was discovered that ammeter reading was low by 1% and resistance was marked high by 0.5%. Find true power as a percentage of the original power.
A 0-400V voltmeter has a guaranteed accuracy of 1% of full scale reading. The voltage measured by this instrument is 250 V. Calculate the limiting error in percentage.
A resistor of 10 k with the tolerance of 5% is connected in parallel with 5 k resistors of 10% tolerance. What is the tolerance limit for a parallel network?

Resistances R1 and R2 have respectively, nominal values of 10 and 5 and limiting error of 5% and 10%. The percentage limiting error for the series combination of R1 and R2 is?

Discussion

No Comment Found

Related MCQs

Reply to Comment

Resistances R₁ and R₂ have respectively, nominal values of 10 and 5 and limiting error of 5% and 10%. The percentage limiting error for the series combination of R₁ and R₂ is?