Relation between throat and leg for a parallel fillet weld is – McqOptions

MCQOPTIONS

1.	Relation between throat and leg for a parallel fillet weld is
A.	t =h Cos (45‚Äö√Ñ√∂‚àö√ë‚àö¬•)
B.	h =t Cos (45‚Äö√Ñ√∂‚àö√ë‚àö¬•)
C.	h= t
D.	None of the listed
Answer» B. h =t Cos (45‚Äö√Ñ√∂‚àö√ë‚àö¬•)

Discussion

No Comment Found

Related MCQs

Strength of parallel fillet weld is greater than strength of transverse fillet weld.
With reference to figure 1, a plate, 75mm wide and 10mm thick, is joined with another plate as shown. The permissible tensile and shear stress in the welds are 50/mm² and 40N/mm². Determine the required length of each parallel fillet weld if length of transverse weld is 40mm.
The two plates are welded as shown in the figure 1. It is an example of
Referring to figure 1, determine the required length of the weld joining two steel plates which are 10mm wide and 10mm thick. The permissible shear stress in the weld is 80N/mm²
If length of weld is l and leg h, then area of throat can be given bya) 0.707 hlb) 1.414hlc) hld) None of the listed Figure 17. A steel plate is welded to another steel plate as shown in the figure 1. This is an example of transverse fillet weld.
Parallel fillet weld and transverse fillet weld both have the plane in which maximum shear stress occurs at 45’ to the leg dimension.
Strength of parallel fillet weld is greater than strength of transverse fillet weld.$
If length of weld is l and leg h, then area of throat can be given by
Relation between throat and leg for a parallel fillet weld is
The length of each of the two equal sides of a parallel fillet weld is called