Pick out the wrong statement pertaining to the design of the distillat – McqOptions

MCQOPTIONS

1.	Pick out the wrong statement pertaining to the design of the distillation column?
A.	Generally, a skirt clearance of 0.5″ to 1.5′ is recommended to prevent plugging of the slots by residue build up
B.	The purpose of the slot is to disperse the gas into the liquid in the form of small bubbles
C.	If sufficient slot area is not provided, the gas may pass through the skirt clearance
D.	None of these
Answer» E.

Discussion

No Comment Found

Related MCQs

Width and depth of grooves in the tube sheet holes normally are _______________ inch respectively?
Wind load consideration in the design of a support can be neglected, when the vessel is___________________?
With increase in gas flow rate to fabric surface area ratio (Nm3/hr/m2 fabric surface area), the size & the cost of a bag filter___________________?
With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will________________?
With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, FT_________________?
With increase in the reflux ratio for a fixed production from a continuous binary distillation column, the ______________________ decreases?
Which of the following is the best tube material from thermal conductivity point of view alone ?
Which of the following is not a graphical method (but is an analytical method) for the calculation of theoretical number of stages in case of continuous binary distillation ?
When one of the fluids is highly corrosive and has fouling tendency, it should_____________________?
What is the value of ‘q’ for saturated vapor feed to a distillation column? (where q = fraction of the feed stream that is liquid ?