What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?

What should the configuration register value be after you successfully

1.	What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
A.	<i class="networking-code">0x2100</i>
B.	<i class="networking-code">0x2101</i>
C.	<i class="networking-code">0x2102</i>
D.	<i class="networking-code">0x2142</i>
Answer» D. <i class="networking-code">0x2142</i>

Discussion

No Comment Found

Related MCQs

What VTP mode allows you to change VLAN information on the switch?
You want to improve network performance by increasing the bandwidth available to hosts and limit the size of the broadcast domains. Which of the following options will achieve this goal?
Which of the following provide inter-switch VLAN communication? <ol class="networking-ol-123"><li> ISL </li><li> VTP </li><li> 802.1Q </li><li> 802.3Z </li></ol>
Which of the following protocols are used to configure trunking on a switch? <ol class="networking-ol-123"><li> VLAN Trunk Protocol </li><li> VLAN </li><li> 802.1Q </li><li> ISL </li></ol>
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? <ol class="networking-ol-123"><li> Each end of the trunk link must be set to the IEEE 802.1e encapsulation. </li><li> The VTP management domain name of both switches must be set the same. </li><li> All ports on both the switches must be set as access ports. </li><li> One of the two switches must be configured as a VTP server. </li><li> A rollover cable is required to connect the two switches together. </li><li> A router must be used to forward VTP traffic between VLANs. </li></ol>
Which command will show you all the translations active on your router?
Which command would you place on interface connected to the Internet?
Which command would you place on interface on a private network?
Port Address Translation is also termed what?
When creating a pool of global addresses, which of the following can be used instead of the netmask command?

What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?

Discussion

No Comment Found

Related MCQs

Reply to Comment