Leak type bias is used in a plate-modulated class C amplifier to – McqOptions

MCQOPTIONS

1.	Leak type bias is used in a plate-modulated class C amplifier to
A.	prevent tuned circuit damping
B.	prevent over modulation
C.	increase the bandwidth
D.	prevent excessive grid current
Answer» C. increase the bandwidth

Discussion

No Comment Found

Related MCQs

<p>What about the stability of system in <img src="/_files/images/electronics-and-communication-engineering/signals-and-systems/19-326.png"></p>
<p>An energy signal has G(<i>f</i>) = 10. Its energy density spectrum is</p>
<p>The first geostationary satellite launched in 1965 was called</p>
<p>Rotation of a geosynchronous satellite means its</p>
<p>The present total cost per watt of power generation in geosynchronous orbit is nearly Rs.</p>
<p>For F<sub>1</sub> layer the maximum ionic density is 2.3 x 10<sup>4</sup> electrons per cc. The critical frequency for this layer will be</p>
<p>Which one of the following does represents the electric field lines for the TE<sub>02</sub> mode in the cross section of a hollow rectangular metallic waveguide?</p>
<p>Radiation intensity of a dipole depends strongly on frequency. If at a frequency <i>f</i>, the intensity of radiation is 'I'. Then at a frequency of <i>f</i>/2, the intensity will be</p>
<p>The input impedance of short-circuited line of length <i>l</i> where /4 < <i>l</i> < /2, is</p>
<p>A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.</p>