An angle modulated signal is expressed by fa(t) = cos (2 x 108 pt) + 75 sin (2 x 103 pt). The peak frequency deviation of the carrier is

An angle modulated signal is expressed by fa(t) = cos (2 x 108 pt) + 7

1.

An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is

A. 1 kHz

B. 7.5 kHz

C. 75 kHz

D. 100 MHz

Answer» D. 100 MHz

Discussion

No Comment Found

Related MCQs

What about the stability of system in <img src="/_files/images/electronics-and-communication-engineering/signals-and-systems/19-326.png">

An energy signal has G(f) = 10. Its energy density spectrum is

The first geostationary satellite launched in 1965 was called

Rotation of a geosynchronous satellite means its

The present total cost per watt of power generation in geosynchronous orbit is nearly Rs.

For F1 layer the maximum ionic density is 2.3 x 104 electrons per cc. The critical frequency for this layer will be

Which one of the following does represents the electric field lines for the TE02 mode in the cross section of a hollow rectangular metallic waveguide?

Radiation intensity of a dipole depends strongly on frequency. If at a frequency f, the intensity of radiation is 'I'. Then at a frequency of f/2, the intensity will be

The input impedance of short-circuited line of length l where /4 < l < /2, is

A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.

An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is

Discussion

No Comment Found

Related MCQs

Reply to Comment

1.	An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
A.	1 kHz
B.	7.5 kHz
C.	75 kHz
D.	100 MHz
Answer» D. 100 MHz