On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?

On a VLSM network, which mask should you use on point-to-point WAN lin

1.	On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?
A.	/27
B.	/28
C.	/29
D.	/30
Answer» E.

Discussion

No Comment Found

Related MCQs

A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts?
Which configuration command must be in effect to allow the use of 8 subnets if the Class C subnet mask is 255.255.255.224?
Using the illustration from the previous question, what would be the IP address of S0 if you were using the first subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. Again, the zero subnet should not be considered valid for this question.
You have a network with a subnet of 172.16.17.0/22. Which is the valid host address?
You have an interface on a router with the IP address of 192.168.192.10/29. What is the broadcast address the hosts will use on this LAN?
Using the following illustration, what would be the IP address of E0 if you were using the eighth subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. The zero subnet should not be considered valid for this question.
What is the subnetwork address for a host with the IP address 200.10.5.68/28?
On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?
To test the IP stack on your local host, which IP address would you ping?
You need to configure a server that is on the subnet 192.168.19.24/29. The router has the first available host address. Which of the following should you assign to the server?

On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?

Discussion

No Comment Found

Related MCQs

Reply to Comment