Laysimeter is used to measure – McqOptions

MCQOPTIONS

1.	Laysimeter is used to measure
A.	Infiltration
B.	Evaporation
C.	Vapour pressure
D.	Evapotranspiration
Answer» E.

Discussion

No Comment Found

Related MCQs

During a storm, the rates of rainfall observed at a frequency of 15 min for one hour are 12.5, 17.5, 22.5 abd 7.5 cm/h. If the phi-index is 7.5 cm/h, then the total run-off will be
Calculate the evaporation (mm) from a pond, if the pan evaporation is 45 mm. The pan coefficient is 0.70.
Rainfall of intensity 20 mm/h occurred over a watershed of area 1 km2 for duration of six hours. It measures a direct runoff for a volume of 30,000 m3 in the stream. Find the precipitation NOT available for runoff in this case?
Horton’s infiltration capacity is given as
_________ plays an important part in completion of hydrological cycle
Meyer’s formula is an empirical formula used to determine?
For a large catchment, contours joining points of equal monthly rainfall values were plotted. The plot is known as:
Laysimeter is used to measure
Infiltration rate is always
A 4-hr storm had 4 cm of rainfall and the resulting direct runoff was 2.0 cm. If the ϕ -index remains at the same value, the runoff due to 10 cm of rainfall in 8 hour in the catchment will be: