In which of the following metalworking process, the control on grain s – McqOptions

MCQOPTIONS

1.	In which of the following metalworking process, the control on grain size is maximum?
A.	Cold working
B.	Hot-working
C.	Cold-annealed-cold working
D.	Cold-annealed-hot working
Answer» D. Cold-annealed-hot working

Discussion

No Comment Found

Related MCQs

The gutter flash is associated with which of following metalworking process?
The residual stress in the material after metalworking can be detected by which of the following method?
The LPG cylinder is manufactured by which of the following metal working process?
In which of the following process, the container wall friction is absent?
In deep drawing to obtain the best result, which of the following property should be minimum?
If the width is decreased by 20% and length is elongated by 30%. Find the plastic strain ratio of the workpiece?
The plastic strain ratio is defined as the _______________ (where W<sub>i</sub>, W<sub>f</sub> is initial and final width of work piece, L<sub>i</sub>, L<sub>f</sub> is initial and final length of work piece).
The dynamic recrystallization occurs at high dislocation density whereas the dynamic recovery occurs at lower dislocation density.
As the strain rate of deformation increases, the temperature of the workpiece due to internal heating ____________
In which of the following metal working process, the temperature is kept highest?