In TM mode, what is the first propagating mode?

1.	In TM mode, what is the first propagating mode?
A.	TM01 mode
B.	TM11 mode
C.	TM12 mode
D.	TM10 mode
Answer» B. TM11 mode

Discussion

No Comment Found

Related MCQs

The cutoff frequencies of the first two propagating modes of a Teflon on a filled circular waveguide with a=0.5 with ∈r=2.08 is:
If β is 0.3 for a circular wave guide operating in TM12 mode with P21=5.315, with the radius of the circular waveguide being equal to 25 mm, then the intrinsic impedance of the wave is:
For TM01 mode of propagation in a circular waveguide with P01=2.405, with the inner diameter of the circular waveguide being equal to 25 mm. What is the cut off frequency for this mode of propagation?
In a circular waveguide, if the propagation is in TE21 mode with P21=3.054, with a diameter of 60 mm, then the cutoff frequency for the mode is:
What is the cutoff frequency for TE₁₁ mode in a circular waveguide of radius 2 cm with P’₁₁= 1.841?
Bessel’s differential equation for a circular waveguide is:
In TE mode of a circular waveguide, EZ=0. The wave equation is:
FOR_TM01_MODE_OF_PROPAGATION_IN_A_CIRCULAR_WAVEGUIDE_WITH_P<SUB>01</SUB>=2.405,_WITH_THE_INNER_DIAMETER_OF_THE_CIRCULAR_WAVEGUIDE_BEING_EQUAL_TO_25_MM._WHAT_IS_THE_CUT_OFF_FREQUENCY_FOR_THIS_MODE_OF_PROPAGATION??$
The cutoff frequencies of the first two propagating modes of a Teflon on a filled circular waveguide with a=0.5 with ‚Äö√Ñ√∂‚àö‚Ä†‚àö‚Ä†r=2.08 is:$#
If_‚âà√≠‚Äö√¢¬ß_is_0.3_for_a_circular_wave_guide_operating_in_TM12_mode_with_P<sub>21</sub>=5.315,_with_the_radius_of_the_circular_waveguide_being_equal_to_25_mm,_then_the_intrinsic_impedance_of_the_wave_is:$#

In TM mode, what is the first propagating mode?

Discussion

No Comment Found

Related MCQs

Reply to Comment