In the truss shown below, force in member BC is – – McqOptions

MCQOPTIONS

1.	In the truss shown below, force in member BC is –
A.	100 N tensile
B.	zero
C.	100 N compressive
D.	50 N tensile
Answer» C. 100 N compressive

Discussion

No Comment Found

Related MCQs

What is the aim of workability is to use the lower percentage?
The cement content limit is not permitted unless special consideration has been considered in design?
One of the functions involved in construction management is?
Trusses must be analyzed for forces developed during ____________
When loads are applied to the chords the bending moment developed are determined by assuming chord as a ____________
The trusses are analyzed for dead, wind and ____________
Based on experimental investigations, the members of truss are analyzed on assumption that the joints are _____________
In the pin-jointed truss shown in the figure, the static degree of indeterminacy is
In the following questions, j represents no. of joints and r represents no. of external forces.If a structure has 2j – r no. of members, then it will be ____.
For the truss shown in the figure, the force in the member PQ is