In the figure given below, the resistance R1 is used to – McqOptions

MCQOPTIONS

1.	In the figure given below, the resistance R1 is used to
A.	keep the gate circuit voltage drop minimum
B.	limit the gate current to a safe value when R2 = 0
C.	limit the gate current to a safe value when R2 is very large
D.	allow the gate power dissipation
Answer» C. limit the gate current to a safe value when R2 is very large

Discussion

No Comment Found

Related MCQs

Find the value of R in case of an RC firing circuit which is to be turned on with a source voltage of 150 V and the following parameters.Igt = 2AVd = 1.5VVgt = 125 V
The figure shown below is that of an RC firing circuit.In case of negative cycle at Vs, the capacitor C
The figure shown below is that of a
In case of a R firing circuit with Vgp > Vgt
In case of a R firing with R2 as the variable resistance, Vgp (peak of gate voltage) and Vgt (gate triggering voltage) the value of R2 is so adjusted such that
In the figure given below, the resistance R1 is used to
In case of an RC half wave triggering circuit, the firing angle can be ideally varied between
The diode in the R firing circuit
For a R firing circuit, the maximum value of source voltage is 100 V. Find the resistance to be inserted to limit the gate current to 2 A.
In a resistance firing circuit the firing angle