In_the_current_limit_control_method,_when_the_load_current_reaches_a_p – McqOptions

MCQOPTIONS

1.	In_the_current_limit_control_method,_when_the_load_current_reaches_a_predefined_lower_value,_then$
A.	the chopper is switched off
B.	the chopper is switched on
C.	the source voltage is removed
D.	load voltage goes to zero
Answer» C. the source voltage is removed

Discussion

No Comment Found

Related MCQs

In the current limit control method, when the load current reaches a predefined lower value, then
Which of the following mentioned control strategy/strategies would require a feedback loop?
In the current limit control method, the chopper is switched off when
WHICH_OF_THE_FOLLOWING_MENTIONED_CONTROL_STRATEGY/STRATEGIES_WOULD_REQUIRE_A_FEEDBACK_LOOP??$
In_the_current_limit_control_method,_when_the_load_current_reaches_a_predefined_lower_value,_then$
In the current limit control method, the chopper is switched off whe?
The control strategy in which on and off time is guided by the pervious set of values of a certain parameter is called as
In case of frequency modulation system, ________ is kept constant.
In case of a constant frequency system, Ton = (1/4)T. If the chopping frequency 2 kHz, find the value of Toff.
In pulse width modulation scheme, _________ is kept constant.