In the assembly design of shaft, pulley and key the weakest member is – McqOptions

MCQOPTIONS

1.	In the assembly design of shaft, pulley and key the weakest member is
A.	Pulley
B.	Key
C.	Shaft
D.	None
Answer» C. Shaft

Discussion

No Comment Found

Related MCQs

A/An ______ is used for turning a nut or for holding bolt head while the nut is being screwed on or off the bolt.
In the assembly design of shaft, pulley and key the weakest member is
In designing a shaft, hub and key for a system, weakest member taken is
In flange coupling, bolt pitch circle diameter is selected as, (d = shaft diameter)
In case of saddle key, power is transmitted by means of
In a turn buckle joint, both mating rods will have
A cotter joint is used to connect two rods which are in
In a cotter joint, the width of the cotter at the center is 5 cm, while its thickness is 1.2 cm. The load acting on the cotter is 60 kN. The shear stress developed in the cotter is