In order to prevent distortion in the output signal after amplificatio – McqOptions

MCQOPTIONS

1.	In order to prevent distortion in the output signal after amplification, the input signal must be
A.	Higher than the positive saturation level of the amplifier
B.	Lower than the negative saturation level of the amplifier
C.	Must lie with the negative and the positive saturation level of the amplifier
D.	Both higher than the positive saturation level of the amplifier and lower than the negative saturation level of the amplifier
Answer» D. Both higher than the positive saturation level of the amplifier and lower than the negative saturation level of the amplifier

Discussion

No Comment Found

Related MCQs

The units of voltage gain is
An amplifier has a voltage gain of 100 V/V and a current gain of 1000A/A. the value of the power gain decibel is
If Av, Ai and Ap represents the voltage gain, current gain and power gain ratio of an amplifier which of the below is not the correct expression for the corresponding values in decibel?
Which of the following isn’t true?
Statement 1: Voltage gain of -5 means that the output voltage has been attenuated. Statement 2: Voltage gain of -5db means that the output voltage has been attenuated.
An amplifier operating from ±3V provide a 2.2V peak sine wave across a 100 ohm load when provided with a 0.2V peak sine wave as an input from which 1.0mA current is drawn. The average current in each supply is measured to be 20mA. What is the amplifier efficiency?
AN_AMPLIFIER_HAS_A_VOLTAGE_GAIN_OF_100_V/V_AND_A_CURRENT_GAIN_OF_1000A/A._THE_VALUE_OF_THE_POWER_GAIN_DECIBEL_IS?$
The_units_of_voltage_gain_is$
If A<sub>v</sub>, A<sub>i</sub> and A<sub>p</sub> represents the voltage gain, current gain and power gain ratio of an amplifier which of the below is not the correct expression for the corresponding values in decibel?
What is meant by stability of the an amplified signal?