In Lewis equation for bending stress, gear tooth is considered as – McqOptions

MCQOPTIONS

1.	In Lewis equation for bending stress, gear tooth is considered as
A.	Simply supported
B.	Cantilever beam
C.	Curved beam
D.	None of the above
Answer» C. Curved beam

Discussion

No Comment Found

Related MCQs

A gear having a diameter of 40 cm transmits 10 kW at 250 r.p.m. If the pressure angle is 20°, the force on the tooth of the gear is:
20° full depth involute profile 19 tooth pinion and 37 teeth gear are in mesh. If the module is 5 mm, then the center distance between the gear pair is
Lewis equation in gears is used to evaluate
A spur gear with 20° full depth teeth is transmitting 20 kW at 200 rad/s. The pitch circle diameter of the gear is 100 mm. The magnitude of the force applied on the gear in the radial direction is
A spur gear has a module of 3 mm, number of teeth 16, a face width of 36 mm and a pressure angle of 20°. It is transmitting a power of 3 kW at 20 rev/s. Taking a velocity factor of 1.5, and Modified Lewis form factor of 0.3, the stress in the gear tooth is about
For a vehicle travelling at 24 km/hr having a wheel radius of 0.305 m with overall gear ratio G = 19.915, and when torque transmitted is 203.6 N.m, the engine speed and power are, nearly
A 20º full depth involute spur pinion of 4 mm module and 21 teeth is to transmit 15 kW at 960 rpm. Its face width is 25 mm. Given that the tooth geometry factor is 0.32 and the combined effect of dynamic load and allied factors intensifying the stress is 1.5; the minimum allowable stress (in MPa) for the gear material is
For two meshing gears, their
In Lewis equation for bending stress, gear tooth is considered as
Hardness is induced within the gear teeth to avoid _____.