In industries titanium is hardened through diffusion of carbon. The concentration of carbon at 1mm into the surface of the titanium slab is 0.25kg/m3 and at 3mm the concentration is 0.68kg/m3. The rate at which the carbon is entering into its surface is 1.27*10-9kg/m2.s. calculate the value of diffusion coefficient of carbon.

In industries titanium is hardened through diffusion of carbon. The c

1.	In industries titanium is hardened through diffusion of carbon. The concentration of carbon at 1mm into the surface of the titanium slab is 0.25kg/m3 and at 3mm the concentration is 0.68kg/m3. The rate at which the carbon is entering into its surface is 1.27*10-9kg/m2.s. calculate the value of diffusion coefficient of carbon.
A.	5.91*10-12
B.	5.91*10-10
C.	5.91*10-11
D.	5.91*10-13
Answer» B. 5.91*10-10

Discussion

No Comment Found

Related MCQs

In industries titanium is hardened through diffusion of carbon. The concentration of carbon at 1mm into the surface of the titanium slab is 0.25kg/m3 and at 3mm the concentration is 0.68kg/m3. The rate at which the carbon is entering into its surface is 1.27*10-9kg/m2.s. calculate the value of diffusion coefficient of carbon.
The gas A diffuses through non-diffusing B from point 1 to point 2. The total pressure is 2atm and yA1=0.1 and yA2=0.Then the ratio (dPA/dz)1/(dPA/dz)2 is
Which among the following is the statement of the ‘Fick’s Law’?
At which condition molar flux with respect to a stationary observer and with respect to an observer moving with molar average velocity?
A sheet of Fe 1.0 mm thick is exposed to an oxidizing gas on one side and a deoxidizing gas on the other at 725°C. After reaching steady state, the Fe membrane is exposed to room temperature, and the C concentrations at each side of the membrane are 0.012 and 0.075 wt%. Calculate the diffusion coefficient (m2/sec) if the diffusion flux is 1.4×10-8kg/m2-sec.
For a component A of a mixture, concentration as a function of x is given:CA=5e-10x (x is in cm and CA in mol/liter)Calculate the value of diffusion velocity (m/s)of the component A at the point x=0, if diffusivity of A in the mixture is 2.567*10-5m2/s.
Consider loss of ethanol vapor by diffusion from a half-filled open test tube. At what point in the diffusion path will the contribution of the bulk flow term to the molar flux be maximum?
In the expression for molar flux NA=(NA+NB)CA/C – DABdCA/dz, the terms representing bulk flow and molecular diffusion are, respectively
For what kind of mixtures DAB=DBA holds?

Discussion

No Comment Found

Related MCQs

Reply to Comment