MCQOPTIONS
Bookmark
Saved Bookmarks
→
Surveying
→
Equipments Plotting
→
In a tilted aerial photograph, if the swing is 230...
1.
In a tilted aerial photograph, if the swing is 230°, then the rotation angle is equal to
A.
140°
B.
130°
C.
50°
D.
25°
Answer» C. 50°
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Consider the following methods of preservation of timber : 1. Dipping 2. Brushing or spraying 3. Pressure impregnation The correct sequence in decreasing order of the effectiveness of these methods of preservation is
Consider the following strengths of concrete : 1. Cube strength 2. Cylinder strength 3. Split-tensile strength 4. Modulus of rupture The correct sequence in decreasing order of these strengths is
Consider the following statements : Sand in mortar is needed for 1. decreasing the quantity of cement. 2. reducing shrinkage. 3. decreasing the surface area of the binding material. 4. increasing the strength. Of these statements :
If the pressure carried by a CBR specimen at 2.5 mm penetration is 3.5 N/mm 2 , the CBR of the soil is
The rectangular block shown in the given figure is subjected to pure shear to intensity ' q '. If BE represents the i principal plane and the principal stresses are ? 1 , ? 2 ; then the values of ?, ? 1 and ? 2 will be respectively.
Consider the following statements : 1. An ascending gradient of 1 in 100 meets an ascending gradient of 1 in 120 to form a Valley curve. 2. A falling gradient of 1 in 25 meets a falling gradient of 1 in 50 to form a summit curve. 3. The length of summit curve is determined on the basis of head light sight distance. Which one of the statements given above is/are correct ?
Consider the following statements : Collision diagram is used to 1. study accident pattern 2. eliminate accidents 3. determine remedial measures 4. make statistical analysis of accidents Of these statements :
For designing end bearing piles of square cross-section in clays having average unconfmed compressive strength of 6 t/m 2 , the net ultimate bearing capacity may be taken as
Consider the following statements regarding Plane Table surveying : 1. It is less accurate than chain surveying. 2. It is not necessary to do accurate centering of plane table for small scale survey. 3. Compass rule may be made use for adjusting the plane table transverse. 4. From the instrument station, resectors are drawn to plot the position of object in the field. Of these statements :
A bar of circular cross-section of diameter D is subjected to a torque T at B as shown in the figure given. What is the angle of twist at A ?
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies