In a riveted lap joint, which one is not a failure mode? – McqOptions

MCQOPTIONS

1.	In a riveted lap joint, which one is not a failure mode?
A.	Tearing failure of plate
B.	Bearing failure of plate
C.	Shearing failure of plate
D.	Tensile failure of rivet
Answer» E.

Discussion

No Comment Found

Related MCQs

A rectangular steel plate is joined to a vertical post using four identical rivets arranged as shown below in the figure. The shear load on the worst loaded rivet (in N) approximately is
How can shock absorbing capacity of a bolt be increased
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
In a riveted lap joint, which one is not a failure mode?
Crushing efficiency of riveted joint is given by
A bolt is designed with a large factor of safety, on the basis of
A single parallel fillet weld of total length L and weld size h subjected to a tensile load P, will have what design stress?
If the tearing efficiency of a riveted joint is 60%, then ratio of rivet hole diameter to the pitch of rivets is _____.
During crushing or bearing failure of riveted joints
A circular solid rod of diameter ‘d’ welded to a rigid flat plate by a circular fillet weld of throat thickness ‘t’ is subjected to a twisting moment ‘T’. The maximum shear stress induced in the weld is