In a belt drive system, when the speed of the belt increases

1.	In a belt drive system, when the speed of the belt increases
A.	Co-efficient of friction between the belt and pulley increases
B.	Co-efficient of friction between the belt and pulley decreases
C.	Power transmitted will decrease
D.	Power transmitted will increase
Answer» E.

Discussion

No Comment Found

Related MCQs

A force of 271 N is applied to the brake drum of 2 m diameter in the hand brake system as shown in the figure, where the wrapping angle is 180°. If the coefficient of friction between the drum and the band is 7/22, the braking torque applied in Nm is
If the velocity ratio for an open belt drive is 8 and the speed of driving pulley is 800 r.p.m then considering an elastic creep of 2% the speed of the driven pulley is
In a belt drive system, if T1 is the tension on the tight side, T2 is the tension on the slack side and V is the velocity of the belt, the power transmitted is _______.
If the angle of wrap on a smaller pulley of diameter 250 mm is 120° and the diameter of a larger pulley is twice the diameter of the smaller pulley, then the center distance between the pulleys for an open belt drive is
If T and m represent the maximum tension and mass per unit length of a belt, then the maximum permissible speed of the belt is given by
In a belt drive system, when the speed of the belt increases
Consider the following statements regarding V-belt drive :1. The groove angle of the sleeve is less than the belt section angle2. The efficiency of a V-belt drive is higher than that of a flat belt drive3. The groove angle is so made that the belt gets wedged in the groove Which of the above statements are correct ?
In a pulley and belt drive, if m is mass of belt per unit length the velocity of belt for maximum power transmission is equal to
If 'm' is the mass per unit length of belt, 'T1' is maximum allowable belt tension and 'TC' is centrifugal tension, for maximum power transmission, the velocity of the belt isa) \(\sqrt{\frac{T_1}{3m}}\)b) \(\sqrt{\frac{T_c}{m}}\)c) \(\sqrt{\frac{3T_1}{m}}\)d) \(\sqrt{\frac{m}{T_c}}\)Which of the given above is/are correct?
If the distance between the centers of two pulleys in a belt drive is 0.5 m and the diameter for the larger and smaller pulleys are 1 m and 0.5 m, respectively. The two pulleys in belt drive is connected by an open belt then the angle of contact at the smaller pulley is given by:

In a belt drive system, when the speed of the belt increases

Discussion

No Comment Found

Related MCQs

Reply to Comment