If the tension in tight side and slack side of the belt is 3000 N and – McqOptions

MCQOPTIONS

1.	If the tension in tight side and slack side of the belt is 3000 N and 1500 N, respectively. The effective driving force at the circumference of the driven pulley is given by:
A.	2000 N
B.	1000 N
C.	4500 N
D.	1500 N
Answer» E.

Discussion

No Comment Found

Related MCQs

Crowning of a pulley is done to
In a multiple V belt drive, when a single belt is damaged, it is preferable to change the complete set to _____.
If the tight and slack side tensions in a flat belt running at 1 km/min are 1500 N and 1000 N, the power transmitted is
If there is no slip and the creep in the transmission, then what is the equation for the velocity ratio in the open belt drive?
A shaft is driven with the help of a belt, which is passing over the engine and shaft. The engine is running at 200 rpm. The diameters of engine pulley is 51 cm and that of shaft is 30 cm. The speed of the shaft will be:
In V-belt drive, belt touches _____.
In a belt drive, the condition where there is relative motion between the belt and the pulley surface is known as ________.
An electric motor running at 900 rpm drives a pump at 1500 rpm. If the pulley on the driving shaft is 750 mm in diameter, what is the required size of the pulley on the driven shaft?
If the tension in tight side and slack side of the belt is 3000 N and 1500 N, respectively. The effective driving force at the circumference of the driven pulley is given by:
In a flat belt drive the maximum tension which the belt can be subjected to is T and the mass of the belt per unit length is m kg. The velocity of the belt for maximum power transmission is