If the diameter of the work surface before machining(d1) is 100 mm and – McqOptions

MCQOPTIONS

1.	If the diameter of the work surface before machining(d1) is 100 mm and diameter of the machined surface(d2) is 50 mm.Then the depth of the cut is______ mm.
A.	50
B.	25
C.	15
D.	none of the mentioned
Answer» C. 15

Discussion

No Comment Found

Related MCQs

The larger diameter of shaft is 125 mm and smaller diameter of the shaft is 95 mm. Find the taper. Assume that length of the job and taper is same.
Number of revolution = 50, rpm = 100. Find out the machining time.
Find the feed from the given data (in mm/revolution). cutting speed(cs) =50 mm/minute, depth of cut(d)=100mm, metal removal rate(mrr)= 10 mm/revolution.
Find the cutting speed from the given data (in mm/minute). metal removal rate(mrr) =50 mm*mm*mm/minute, depth of cut(d)=1mm, feed(f)= o.1 mm/revolution.
Find the metal removal rate from the given data (in mm*mm*mm/minute). cutting speed(cs) =50 mm/minute, depth of cut(d)=10mm, feed(f)= o.1 mm/revolution.
If the diameter of the work surface before machining(d1) is 100 mm and diameter of the machined surface(d2) is 50 mm.Then the depth of the cut is______ mm.
Determine the cutting speed(cs) of the shaft mm/min. diameter(d)=25 mm, rpm(n)=50 mm/revolution
Determine the diameter(d) of the shaft in mm. rpm(n)=25 mm/revolution, cutting speed(cs)=100 mm/min.
Determine the rpm(n) of the shaft. diameter(d)=25 mm, cutting speed(cs)=50 m/min.