If K is the transformation ratio, then the secondary phase voltage of – McqOptions

MCQOPTIONS

1.	If K is the transformation ratio, then the secondary phase voltage of delta-delta connected three phase transformer will be
A.	1 / K times of the primary phase voltage
B.	Equal to the primary phase voltage
C.	1 / K ∧ 2 times of the primary phase voltage
D.	K times the primary phase voltage
Answer» E.

Discussion

No Comment Found

Related MCQs

<p> In double delta transformation, a double delta refers to the case where there are two delta transformations in</p>
<p> The value of load angle δ and the internal machine angle ∅ for maximum power developed in synchronous motor is equal to</p>
<p> What happens if a stationary alternator is connected to live bus bar?</p>
<p> If a d.c. series motor is started on very light load or on no load then</p>
<p> If the flux is increased by 50% and speed is reduced by 50% of a d.c. motor (keeping the other parameters constant), then its back emf will become</p>
<p> In a single phase, full wave bridge circuit and in three phase, delta full wave bridge circuit, the ripple voltage frequency is always</p>
<p> During the one complete revolution of the conductor in a 4 pole synchronous generator, induced emf will experience</p>
<p> Which method is suitable for the speed control, below and above the normal rated speed of d.c. shunt motor?</p>
<p> When the induction motor runs faster than the synchronous speed, the induction motor runs as</p>
<p> The performance of induction motor is effected by the harmonics in the</p>