If all the sequence voltages at the fault point in a power system are – McqOptions

MCQOPTIONS

1.	If all the sequence voltages at the fault point in a power system are equal, then fault is __________
A.	LLG fault
B.	LG fault
C.	Three phase to ground fault
D.	Line to Line fault
Answer» B. LG fault

Discussion

No Comment Found

Related MCQs

A lossless TL having SIL of 3000 MW is provided with uniform distributed series capacitance compensation of 25% and shunt compensation of 30% then the compensated impedance of TL will be(in pu) ____________
A lossless TL having SIL of 3000 MW is provided with uniform distributed series capacitance compensation of 25% and shunt compensation of 30% then the SIL of compensated TL will be _______________
For a 100 MVA, 11 kV three phase Alternator observes a three phase fault at terminals of it. If the fault current is 2000 A, the pu value of positive sequence reactance ______
A fault current of 1500A passing through the primary side of a 400/5 CT. On the secondary side an inverse time over current relay is connected whose current setting is 75%, the plug setting is __________
The inertia constant of two groups of machines which do not swing together are 4 and 20 MJ/MVA, the equivalent inertia constant of the system is _________
If all the sequence voltages at the fault point in a power system are equal, then fault is __________
If short TL is delivering a lagging power factor load, sending end p.f. would be ________
An isolated generator connected to a turbine with its continuous maximum power of 20 MW, 50 Hz. Generator connected with two loads of 8 MW, each operate at 50 Hz.. Generator has 5% droop characteristic. If an additional load of 6 MW is added then the change in the frequency will be ____________