High gain is not achievable at microwave frequencies using BJT amplifi – McqOptions

MCQOPTIONS

1.	High gain is not achievable at microwave frequencies using BJT amplifiers because:
A.	device construction
B.	complex architecture
C.	ports are not matched at high frequencies
D.	none of the mentioned
Answer» D. none of the mentioned

Discussion

No Comment Found

Related MCQs

____________ uses balanced input and output, meaning that there are 2 signal lines, with opposite polarity at each port.
ALONG_WITH_A_DIFFERENTIAL_AMPLIFIER,_1800_HYBRID_IS_USED_BOTH_AT_THE_INPUT_AND_OUTPUT.?$
A_MAJOR_ADVANTAGE_OF_DIFFERENTIAL_AMPLIFIERS_IS:?$
____________ uses balanced input and output, meaning that there are 2 signal lines, with opposite polarity at each port?
In distributed amplifiers, all the FET stages in the amplifier are connected in series to one another.
Distributed amplifiers offer very high _________
Coupler that is mostly used in balanced amplifiers to achieve the required performance is:
Bandwidth of balanced amplifier can be an octave or more, but is limited by the bandwidth of the coupler.
In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:
To flatten the gain response of a transistor: