Generally in load flow analysis, the load is modelled as a

1.	Generally in load flow analysis, the load is modelled as a
A.	constant impedance load
B.	constant power load
C.	constant current load
D.	dynamically varying load
Answer» C. constant current load

Discussion

No Comment Found

Related MCQs

A 10-bus power system consists of four generator buses indexed as G1, G2, G3, G4 and six load buses indexed as L1, L2, L3, L4, L5, L6. The generator-bus G1 is considered as slack bus, and the load buses L3 and L4 are voltage-controlled buses. The generator at bus G2 cannot supply the required reactive power demand, and hence it is operating at its maximum reactive power limit. The number of non-linear equations required for solving the load flow problem using Newton-Raphson method in polar form is ___________.
For a 15-bus system power system with 3 voltage-controlled buses, the size of Jacobian matrix of Newton-Raphson method used to solve load flow problem is:
Compared to Gauss-Seidel method, Newton-Raphson method takes
In Gauss-Seidel’s method of power flow solution, the acceleration factor is used for
Generally in load flow analysis, the load is modelled as a
α (Alpha) in G-S load flow method is used:
A 1000 × 1000 bus admittance matrix for an electric power system has 8000 non-zero elements. The minimum number of branches (transmission lines and transformers) in this system are:
In a power system, there are 50 buses as follows:Slack bus = 1Generator buses = 8Load buses = 41By the Newton-Raphson method, the size of the Jacobian matrix is:
In Gauss-Sidel load flow method, the number of iterations may be reduced if the correction in voltage at each bus is multiplied by,
A 3-Bus network is shown. Consider generators as ideal voltage sources. If rows 1, 2 and 3 of the YBus matrix correspond to Bus 1, 2 and 3, respectively, then YBus of the network is

Generally in load flow analysis, the load is modelled as a

Discussion

No Comment Found

Related MCQs

Reply to Comment