Friction and resistance cause energy loss in form of

1.	Friction and resistance cause energy loss in form of
A.	Electrical energy
B.	Potential Energy
C.	Thermal energy
D.	Kinetic energy
Answer» D. Kinetic energy

Discussion

No Comment Found

Related MCQs

The slender 200-kg beam is suspended by a cable at its end as shown. If a man pushes on its other end with a horizontal force of 30 N, determine the initial acceleration of its mass center G, the beam's angular acceleration, and the tension in the cable AB.
If the cable CB is horizontal and the beam is at rest in the position shown, determine the tension in the cable at the instant the towing force F = 1500 N is applied. The coefficient of friction between the beam and the floor at A is A = 0.3. For the calculation, assume that the beam is a uniform slender rod having a mass of 100 kg.
A woman sits in a rigid position on her rocking chair by keeping her feet on the bottom rungs at B. At the instant shown, she has reached an extreme backward position and has zero angular velocity. Determine her forward angular acceleration and the frictional force at A necessary to prevent the rocker from slipping. The woman and the rocker have a combined weight of 180 lb and a raduis of gyration about G of kG = 2.2 ft.
A clown, mounted on stilts, loses his balance and falls backward from the position, where it is assumed the = 0 when = 07deg;. Paralyzed with fear, he remains rigid as he falls. His mass including the stilts is 80 kg, the mass center is at G, and the radius of gyration about G is kG = 1.2 m. Determine the coefficient of friction between his shoes and the ground at A if it is observed that slipping occurs when = 30°.
The wheel has a weight of 30 lb, a radius of r = 0.5 ft, and a radius of gyration of kG = 0.23 ft. If the coefficient if friction between the wheel and the plane is = 0.2, determine the wheel's angular acceleration as it rolls down the incline. Set = 12°.
If the support at B is suddenly removed, determine the initial reactions at the pin A. The plate has a weight of 30 lb.
The disk has a mass of 20 kg and is originally spinning at the end of the massless strut with an angular velocity of = 60 rad/s. If it is then placed against the wall, for which A = 0.3, determine the time required for the motion to stop. What is the force in strut BC during this time?
A cord wrapped around the inner core of a spool. If the cord is pulled with a constant tension of 30 lb and the spool is originally at rest, determine the spool's angular Velocity when s = 8 ft of cord have unraveled. Neglect the weight of the cord. The spool and cord have a total weight of 400 lb and the radius of gyration about the axle A is kA = 1.30 ft.
The 15-lb rod is pinned and has an angular velocity of = 5 rad/s when it is in the horizontal position shown. Determine the rod's angular acceleration and the pin reactions at this instant.
The dragster has a mass of 1.3 Mg and a center of mass at G. If a braking parachute is attached at C and provides a horizontal braking force FD, determine the maximum deceleration the dragster can have upon releasing the parachute without tipping the dragster over backwards (i.e., the normal force under the wheels and assume that the engine is disengaged so that the wheels are freely rolling.

Friction&nbsp;and&nbsp;resistance&nbsp;cause&nbsp;energy&nbsp;loss&nbsp;in&nbsp;form&nbsp;of

Discussion

No Comment Found

Related MCQs

Reply to Comment

Friction and resistance cause energy loss in form of