For the circuit shown diode cutting voltage is Vin = 0. The ripple vol – McqOptions

MCQOPTIONS

1.	For the circuit shown diode cutting voltage is Vin = 0. The ripple voltage is to be no more than vrip = 4 V. The minimum load resistance, that can be connected to the output is (in kilo ohm)
A.	6.25
B.	12.5
C.	25
D.	30
Answer» B.

Discussion

No Comment Found

Related MCQs

The Q-point of the zener diode in the circuit shown below is
The circuit inside the box in fig. P3.1.31. contains only resistor and diodes. The terminal voltage vo is connected to some point in the circuit inside the box. The largest and smallest possible value of vo most nearly to is respectively
For the circuit shown diode cutting voltage is Vin = 0. The ripple voltage is to be no more than vrip = 4 V. The minimum load resistance, that can be connected to the output is (in kilo ohm)
The maximum load current that can be drawn is
Determine the output waveform from the given circuit and input waveform.
Find the output waveform from the given circuit and input waveform.
For the given circuit and input waveform determine the output waveform.