For display of signal pattern _____________voltage is applied to the – McqOptions

MCQOPTIONS

1.	For display of signal pattern _____________voltage is applied to the horizontal plates of a CRO?
A.	Sinusoidal
B.	Rectangular
C.	Sawtooth
D.	None of the above
Answer» D. None of the above

Discussion

No Comment Found

Related MCQs

<p> A CRO is used to measure _________________?</p>
<p> The horizontal plates of a CRO are supplied with _____________ to observe the waveform of signal?</p>
<p> An ammeter has a resistance of G ohms and range of I amperes. The value of resistance required in parallel to convert it into an ammeter of range nI is______________?</p>
<p> A voltmeter has a resistance of G ohms and range V volts. The value of resistance required in series to convert it into voltmeter of range nV is________________?</p>
<p> An ideal ammeter has ______________ resistance?</p>
<p> Which of the following is likely to have the largest resistance ?</p>
<p> The resistance of an ideal voltmeter is ______________?</p>
<p> To send 10% of the main current through a moving coil galvanometer of resistance 99 O the shunt required is______________?</p>
<p> If 2% of the main current is to be passed through a galvanometer of resistance G, then resistance of the shunt required is ________________?</p>
<p> If the full-scale deflection current of a multimeter is 50 µA, its sensitivity is ________________?</p>