For designing a communication system, which among the following parameters should be maximum?A. Transmission rateB. Received signal-to-noise ratioC. Error probabilityD. Bandwidth requirement

For designing a communication system, which among the following parame

1.	For designing a communication system, which among the following parameters should be maximum?A. Transmission rateB. Received signal-to-noise ratioC. Error probabilityD. Bandwidth requirement
A.	A & B
B.	C & D
C.	A & C
D.	B & D
Answer» B. C & D

Discussion

No Comment Found

Related MCQs

For (n,k) binary BCH code, how are the parity check bits (n k) specified?
The minimum distance of linear block code (d) is equal to minimum number of rows or columns of H, whose_____ is equal to zero vector.
Assuming that the channel is noiseless, if TV channels are 8 kHz wide with the bits/sample = 3Hz and signalling rate = 16 x 10 samples/second, then what would be the value of data rate?
For a (6,4) block code where n = 6, k = 4 and d = 3, how many errors can be corrected by this code?
Which buffer size is required by the interleaved codes at the transmitter for the accumulation of code words?
Consider the assertions related to decoding process of cyclic code. Which among the following is a correct sequence of steps necessary for the correction of errors?A. Syndrome determination after the division of r(x) & g(x) B. Addition of error pattern to received code wordC. Selection of error pattern corresponding to the syndromeD. Preparation of table comprising error patterns and syndromes
Which among the below stated logical circuits are present in encoder and decoder used for the implementation of cyclic codes?A. Shift RegistersB. Modulo-2 AddersC. CountersD. Multiplexers
Decoding of RS code comprises the determination of error _______A. positionB. magnitudeC. angleD. frequency
For a Gaussian channel of 1 MHz bandwidth with the signal power to noise spectral density ratio of about 10 Hz, what would be the maximum information rate?
For fixed symbol rate, increase in bits/symbol ultimately improves r/B bits/s/Hz & hence, regarded as _____.

For designing a communication system, which among the following parameters should be maximum?A. Transmission rateB. Received signal-to-noise ratioC. Error probabilityD. Bandwidth requirement

Discussion

No Comment Found

Related MCQs

Reply to Comment