MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Agricultural Engineering
→
General
→
For better alignment, a cutter bar should be set a...
1.
For better alignment, a cutter bar should be set at
A.
80?
B.
82?
C.
86?
D.
88?
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
The camshaft controls
The gang angle of disc harrow is adjusted in the range of
The increase in tilt angle of disc plough influences
The mould board plough absorb side forces mainly through the
Heavy smoking in an engine during operation may be due to
A thresher causes more seed damage if
Medium size bullock can develop
The mechanical efficiency of spray pumps ranges from
The fan of radiator is driven by
Parboiling of paddy is done to
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
