For any mode of propagation in a rectangular waveguide, propagation oc – McqOptions

MCQOPTIONS

1.	For any mode of propagation in a rectangular waveguide, propagation occurs:
A.	Above the cut off frequency
B.	Below the cut off frequency
C.	Only at the cut-off frequency
D.	Depends on the dimension of the waveguide
Answer» B. Below the cut off frequency

Discussion

No Comment Found

Related MCQs

In TE01 mode of wave propagation in a rectangular waveguide, if the smaller dimension of the waveguide is 2 cm, then the cutoff wavelength for that mode is:
In TE10 mode of wave propagation in a rectangular waveguide, if the broader dimension of the waveguide is 40 cm, then the cutoff wavelength for that mode is:
The cutoff frequency for the dominant mode in TM mode propagation for a rectangular waveguide of dimension of 30mm*40mm is:
The lowest mode of TM wave propagation is:
For dominant mode propagation in TE mode, if the rectangular waveguide has a broader dimension of 31.14 mm , then the cutoff wave number:
TEₒₒ mode for a rectangular waveguide:
For TE1ₒ mode, if the waveguide is filled with air and the broader dimension of the waveguide is 2 cm, then the cutoff frequency is:
The modes of propagation supported by a rectangular wave guide is:
THE_LOWEST_MODE_OF_TM_WAVE_PROPAGATION_IS:?$
In TE10 mode of wave propagation in a rectangular waveguide, if the broader dimension of the waveguide is 40 cm, then the cutoff wavelength for that mode is:$