For an economical design of gravity dam, the shear friction factor cau – McqOptions

MCQOPTIONS

1.	For an economical design of gravity dam, the shear friction factor causec compression strength should lie between____________________?
A.	1.5 to 4.0
B.	2.0 to 4.0
C.	2.5 to 4.5
D.	3 to 5
Answer» B. 2.0 to 4.0

Discussion

No Comment Found

Related MCQs

Wilting point is that limit after that the crop starts feeding up and no water is available for plant, this point occurs after _________________?
Which of the following is a cash crop ___________________?
Which of the following has highest-coefficient of discharge_____________________?
When the weight of weir balances the up lift pressure caused by the head of the water seeping below the weir bed is called ___________________?
When the reservoir is full, the maximum compressive force in a gravity dam is produced ___________________?
When the rate of change of discharge of outlet equals the rate of change of discharge of the channel, the out let is called __________________?
When the high flood level of the drain is sufficiently below the bed of the Canal that the drainage water flows freely under gravity, such structure is called___________________?
When the fluid properties do not change with time, it is a ___________ flow?
When the air in a atmosphere is fully saturated with the vapours present in it, then the pressure exerted by such wet air mass will be called ____________________?
When seepage water after passing the ground water aquifer joins the surface stream, such stream will be called_____________________?