For a unit step signal u (t), the response is V1 (t) = (1-e-3t) for t>0. If a signal 3u (t) + δ(t) is applied, the response will be (considering zero initial conditions)?

For a unit step signal u (t), the response is V1 (t) = (1-e-3t) for t>

1.	For a unit step signal u (t), the response is V1 (t) = (1-e-3t) for t>0. If a signal 3u (t) + δ(t) is applied, the response will be (considering zero initial conditions)?
A.	(3-6e-3t)u(t)
B.	(3-3e-3t)u(t)
C.	3u(t)
D.	(3+3e-3t)u(t)
Answer» D.

Discussion

No Comment Found

Related MCQs

In the circuit given below, the switch is closed at time t=0. The voltage across the inductance just at t=0+ is ____________
In the circuit given below, the capacitor initially has a charge of 10 C. The current in the circuit at t=1 sec after the switch S is closed will be ___________
In the figure given below, what is the RMS value of the periodic waveform?
An ideal capacitor is charged to a voltage VO and connected at t=0 across an ideal inductor L. If ω = \(\frac{1}{\sqrt{LC}}\), the voltage across the capacitor at time t>0 is ____________
In the circuit given below, the switch S1 is initially closed and S2 is opened. The inductor L carries a current of 10A and the capacitor is charged to 10 V with polarities as shown. The current through L during t=0+ is _____________
In the circuit given below, the switch S1 is initially closed and S2 is opened. The inductor L carries a current of 10A and the capacitor is charged to 10 V with polarities as shown. The current through C during t=0+ is _____________
In the circuit given below, for time t<0, S1 remained closed and S2 open., S1 is initially opened and S2 is initially closed. If the voltage V2 across the capacitor C2 at t=0 is zero, the voltage across the capacitor combination at t=0+ will be ____________
For a unit step signal u (t), the response is V1 (t) = (1-e-3t) for t>0. If a signal 3u (t) + δ(t) is applied, the response will be (considering zero initial conditions)?
Initial voltage on capacitor VO as marked |VO| = 5 V, VS = 8 u (t), where u (t) is the unit step. The voltage marked V at t=0+ is _____________
In the circuit shown below the current I(t) for t≥0+ (assuming zero initial conditions) is ___________

For a unit step signal u (t), the response is V1 (t) = (1-e-3t) for t>0. If a signal 3u (t) + δ(t) is applied, the response will be (considering zero initial conditions)?

Discussion

No Comment Found

Related MCQs

Reply to Comment